Awning repair - that's how it works

Awning repair - that's how it works: adhesive

An awning on the balcony or on the terrace is practical, decorative and very durable. The retractable sunroofs, however, do not last forever either: the UV rays of the sun are as much of a concern to them in the long run as the mechanical strain caused by rolling in and out. Sometimes it's just the aging of the material that leads to cracks, holes or open seams. And who forgets in a hail shower to overtake the awning in time, also has a problem.

Of course, you can rebuild a damaged awning - However, a repair is the much cheaper solution. You do not even have to sew, because many repairs can be done simply by gluing.

In the following you will learn useful tips for fixing different damage spots on awnings.

repair adhesive

Even if the application is not difficult, repairing an adhesive is a demanding task: the repair adhesive used must be suitable for textiles, weather-resistant and UV-stable. In addition, he must withstand the stresses of wind movements and by the retraction and extension of the awning - so he must harden elastically.

by the way: Fabrics made of the plastics polyethylene (PE) and polypropylene (PP) can not be glued, you can only weld them. Coatings made of polytetrafluoroethylene (PTFE, trade name Teflon) also prevent the adhesion of the adhesive.

These plastics are rather exceptions. For all others, the awning repair should not be a problem - read it yourself!

Material and tools

  • Special awning cleaner or water with a little detergent
  • repair adhesive
  • Adhesive tape, spring clips or clothespins
  • Cutter knife, scissors
  • For larger damage a piece of the same or of a similar substance

Awnings repair step by step

Clean adhesive surfaces

Dirt, green cover or greases hinder the adhesion of the adhesive. So first clean at least the adhesive surfaces with awning cleaner or detergent solution and free them from algae or moss. On the occasion you can also make a complete cleaning - the main thing, then the fabric dries completely again.

Bond the fabric

Different damage patterns require different approaches. The following techniques have proven themselves:

Stick smaller cracks with a slight overlap

On one of the surfaces to be bonded apply a few caterpillars of the repair adhesive. Bear in mind that the adhesive should not only connect the adjacent panels but should also seal the repair area.

Place them the other edge of the crack on the splice and fix the closed gap with adhesive tape or depending on the position of the damaged area with clamps or clothespins. So the fabric can not slip while the adhesive cures. This so-called crosslinking of the glue can take some time - usually at least 24 hours. Please follow the instructions of the adhesive manufacturer!

Repair large cracks with patches

A larger or irregular crack in the awning can be usually not close by overlapping. Here is a patch used.

Cut the patch so that it covers the repair area well. The glue is then applied to one side of the patch. Then place the patch with the adhesive side on top of the crack and carefully paint it wrinkle free.

It can be helpful if the edges of the damaged area while holding it from below with adhesive tape become. In any case, you should fix the patch after hanging up as described above and let the damaged area harden for a sufficiently long time.

With really big flaws you come with the awning repair not without a second patch out, which is also glued from below against the crack.

Stick small holes

Here it is sufficient for a successful repair frequently, if one from above a small strip or point awning fabric sticking to the hole. Very small holes can be easily filled with the glue.

Glue awning seam

For example, if seams burst in the edge area, you can do them sew again with a little skill, matching plastic yarn and a strong needle. But even those who have no skills, comes - again with repair adhesive - to the goal.

First, again cleaned the awning fabric on both sides of the seam. Then it has to dry, then wet the seam to be closed on one side with the adhesive. Apply it completely, otherwise water may later penetrate through the not quite closed seam.

The repaired suture is also fixed during hardening. Most are here Staples or spring clips the most practical solution, but also a tape makes it useful.

Tips for a successful awning repair

  1. If it begins to rain during the curing time of the adhesive, you must roll up the awning. In order to avoid unwanted connections, generously lay PE film over the repair area. This can be a grocery bag, a clean garbage bag or cling film. Roll in the foil and immediately remove the awning after rain.
  2. Well maintained awnings last longer. This includes above all the right cleaning. Here is enough clear water with a dash of detergent completely. If you want, you can also buy a special awning cleaner. Sharp means or high-pressure cleaners, however, are taboo.
  3. Thinking ahead is worthwhile: If you buy a spare piece of fabric when purchasing an awning, then you will have a suitable patch at hand immediately.

Similar sites

  • Fold 3D stars
  • Tinker lampshade yourself
  • Build terrace roofing
  • Build a wooden spice rack yourself
  • Building pallet chairs - construction manual for garden armchairs made of pallets
  • Shutters yourself - building instructions for shutters
  • Clean the oven
  • Defrost the fridge properly
  • Repair the washing machine
  • Building instructions for birdhouses
  • Build sideboard shelf - blueprint with construction manual
  • Cushion the seat itself
  • Build practical wardrobe furniture and wall shelves
  • Build your own game tower: Spielhaus construction manual
  • Repair blinds yourself

Video Board: How To Replace an RV Patio Awning + New Fabric Discount