If the toilet is broken


If the toilet is broken, that means a big annoyance, which can pass on. If the toilet in your own home or condo is broken, you can of course start repairing immediately. To this end, we have summarized the main causes of a toilet defect in order to better isolate the damage. In a rented property, however, the situation may be more difficult. Also for the broken toilet in the rental apartment, we have below information and tips for you.

Toilet defect in the residential property or in the rental property

Disorders of the toilet occur again and again, after all, the toilet is in daily use. But before you can deal with the repair, the responsibility must be clarified, at least in a toilet in a rental apartment or a rented house. Basically, the landlord is obliged to repair.

The situation as a tenant

It may be that small and cosmetic repairs up to a certain amount of money according to the lease can be transferred to the tenant. Therefore, always look into the lease. But if it is a major loss, it is in any case the landlord, who is obliged to repair.

Rent reductions for toilet damage

Otherwise, you can even claim a rent reduction, because an apartment without a functioning toilet can be used only very limited. But as so often, there are a variety of court decisions:

  • Up to 80 percent rent reduction if the only toilet in the apartment is unusable
  • a freezing toilet: Tenant can terminate without notice
  • Up to 40 percent rent reduction for runoff with odor
  • up to 15 percent if the conditioner is too weak to remove faeces
  • up to 10 percent for cracked toilet ceramics

Classic toilet damage

On the other hand there are defects in the toilet, which can not only be repaired in the owner-occupied home. The extent to which a tenant can or must carry out these repairs himself is defined by the rental agreement and tenancy law. The following defects on a toilet occur by far the most common:

  • Water rinse is not tight
  • Water pressure is too low
  • The toilet is blocked
  • the toilet seat is not fixed (wobble)
  • the water consumption is too high

A running water flush

If the cistern is leaking at your toilet, there are several possible causes. It may be age-old seals on the outlet or inlet valve. In addition, the inlet valve may not shut off the supply via the float because it is too low or incorrectly set. Then the water comes out of the overflow into the toilet bowl. The descaling of the toilet cistern can also help.

The pressure of the incoming water is too low

Here, a distinction must be made between two possibilities:

  • the water pressure from the cistern to the toilet is too weak
  • the pressure of the incoming water in the emptied cistern water is low and takes a long time

If the pressure of the water in the toilet bowl is too low, several causes can be considered. The outlet valve does not open properly because the actuating mechanism has a defect. Then you have to fix the cistern. Likewise, however, there may also be a calcification.

The toilet is blocked

A clogged toilet most people have experienced before. Most of the time you feel almost confirmed by "Murphy's Law" (the sausage bread always ends up with the sausage down on the floor), because after all, you obviously have no tools or other tools at home while the shops are already closed. Nevertheless, there are numerous remedies and home remedies, which one has with a little luck at home. Here you will find numerous successful home remedies: Toilet clogged - what to do?

The toilet glasses wobble

Even the toilet goggles, which slide back and forth, know most already. In many cases, however, hardly anything can be done. Often very cheap toilet goggles are starting to wobble quickly. What you can still do when the toilet lid wobbles, you will learn here.

The toilet water consumption is too high

That too is a problem many people already know. Only a few are really aware of how much money they could save here. Under "Water consumption of toilet flushing" we have vividly discussed for you how much savings potential can exist in your toilet water flushing.

Tips & Tricks

Calcifications do not usually come alone. For strongly calcareous, so hard water, reacts chemically when meeting with urine. The result is urine stone. This allows you to completely avoid limescale as well as urine scale when converting the water rinse to rainwater, since rainwater is neutral. In addition, you save valuable drinking water, which is not wasted for toilet flushing.
If the toilet is broken

FAQ - 💬

❓ What to do if toilet breaks?

👉 How to fix a toilet flush handle

  1. Take the lid off the toilet cistern.
  2. Unhook and remove the trip lever. ...
  3. Unscrew the nut that holds the handle in place. ...
  4. Remove the handle.
  5. Take the handle to a DIY store to get a new one.
  6. Slot the new handle into position. ...
  7. Slide the trip lever onto the end of the handle and re-hook it.

❓ How do you tell a toilet is broken?

👉 8 Signs Your Toilet Needs to Be Replaced

  1. Constant Clogging. Nobody likes to deal with a clogged toilet. ...
  2. Cracks. When you notice puddles of water around your toilet, you may want to check for cracks in the porcelain. ...
  3. Plentiful Repairs. ...
  4. Excessive Age. ...
  5. Wobbling. ...
  6. Inefficient Flushing. ...
  7. Surface Damages. ...
  8. Built-Up Mineral Deposits.

❓ Can you fix a broken toilet?

👉 Hairline cracks often can be patched with a porcelain epoxy. Larger cracks or cracks that penetrate fully through a bowl usually cannot be repaired, requiring that the toilet be replaced.

❓ Can you flush a toilet if the flush is broken?

👉 Simply fill the toilet tank with water until it reaches the top of the overflow tube. You can then flush your toilet with the flush handle as you normally would. There's also another method to consider, which is referred to as a "gravity flush." You'll need to quickly pour about 1.6 gallons of water in the toilet bowl.

❓ How do you fix a toilet that won't flush?

👉 Heat a gallon of water on the stove, then add a squirt or two of dish soap to the toilet bowl. Pour the water into the toilet, ensuring that you don't pour so much that it causes the bowl to overflow. Wait about 15 minutes to give the soap and hot water a chance to soften the clog, then flush it.

❓ How do you flush without water?

👉 How To Flush A Toilet Without Running Water

  1. Use a bucket of water (or two) to flush the toilet. ...
  2. Pour slowly in the beginning, then quickly dump the remainder of the water into the bowl. ...
  3. You do not need to use the handle or empty the tank.

❓ How long should toilets last?

👉 50 yearsToilets can last for up to 50 years under average conditions. However, this doesn't mean that you won't need to spend money maintaining it throughout its useful life. Furthermore, there are many factors that could cause your toilet to fail in less than 50 years.

❓ What are common toilet problems?

👉 These are:

  • Damaged fill tube. A fill tube is a plastic hose that is responsible for sending water back into the toilet tank after it has been flushed. ...
  • Cracked toilet bowl. Cracked toilet bowls are quite rare but they still happen. ...
  • Faulty vent. ...
  • Damaged fill valve.

❓ How do you flush a toilet when the handle wont work?

👉 You can actually flush the toilet by pouring water into the bowl until it flushes. If there's a wastebasket that can hold water, empty it, fill it with water and pour the water into the toilet. If enough water is poured into the bowl at once, the contents will flush down the drain.

❓ Is my toilet clogged or broken?

👉 One good way you can check is with a gallon of water. Take the water and pour it into the toilet bowl. If the water immediately rises, then the issue is a clogged drain. If the water sinks or stays the same, then the problem is more likely in the toilet tank.

❓ What is a toilet flapper?

👉 A toilet flapper is the part of your toilet that seals the opening between the tank and the toilet bowl. When the toilet is flushed, a rubber tank ball or flapper lifts out of the way, and water rushes into the bowl.

👉 Although it might sound unexpected, one of the biggest problems that could occur in your toilet system is a broken toilet handle. Since most people usually don’t think about this issue, probably because it’s not the first thing that comes to mind when you need to use the toilet, you would be surprised by the consequences of this malfunction.

👉 Yes, this does happen. Call a plumber right away if you notice any floor or ceiling damage. Sometimes a toilet leaks around the base and it has nothing to do with the wax ring. For example, sometimes the bolts that attach the toilet to the floor cause water to leak out from base.

👉 Normally this problem is caused because of problems with the wax ring that seals the base of the toilet (the horn) to the drain opening set into the floor. You'll have to remove the toilet in order to replace the wax ring. Although this might seem like a major project, it's actually not all that hard.

👉 If water is not present, you can proceed with the repair. But if there are signs of leaking around the base, it likely means that the wax ring sealing the toilet horn to the toilet flange has become old and compressed. In this case, you must remove the toilet and replace the wax ring.


Video Board: Easy fix toilet rocking or leaking yourself if closet flange bolts are broken