Clean the water bag in the dishwasher

The water bag attached to the side of the dishwasher can often be cleaned without removal. Nevertheless, if the contamination is very persistent or old, removal and more intensive cleaning sometimes can not be avoided. However, this requires knowledge of the function of the solenoid valve.

First try without removing

One of the first possible causes when a dishwasher stinks is the contamination of the water bag. Also referred to as a water sensor component has a float and thin water flow nozzles, where dirt, fungi and mold can begin.

When cleaning the dishwasher, it is always worthwhile first to perform a run with liquid detergents before dismantling is envisaged. The plastics that make up the water pockets of modern dishwashers are resistant to strong chemical agents such as drain cleaners, acids and alkalis.

If the expansion is required because the continuous cleaning is not sufficient, the residual water must first be drained from the water bag. For this process, the solenoid valve is energized on one side, but this should only be done with the appropriate expertise.

How to clean the water bag

  • special cleaners
  • denture cleaners
  • drain cleaner
  • caustic soda
  • citric acid
  • Bucket or container
  • Absorbent rag
  • neodymium
  • Needle or nail centerpiece without head

1st continuous cleaning without removal

Pour pipe or drain cleaner into your dishwasher and let it pass through at the highest temperature level. Repeat this procedure with caustic soda and with dilute citric acid. Finally, run through two to three empty rinses with clear water to rinse any chemical residue.

2. Remove the water bag

Unscrew the side panel of the dishwasher. After emptying the water bag, loosen the retaining screws and disassemble the usually three water hoses. Take the water bag out of the machine.

3. Soak the water bag

Place the water bag in a jar or tub with mixed cleansers such as denture cleaners, citric acid or chemical household cleaners. Let the water bag soak in the cleaning bath for several hours.

4. Rinse the water bag

Rinse the water bag with water pressure by holding the water hose to the different water nozzles. Rinse several times in each direction.

5. Scrape out the water bag

Insert a nail centerpiece and move it back and forth within the water pocket and dirty sewers, scraping out the dirt. Rinse in between again and again.

Tips & Tricks

After installing the machine, the waste water bend in the water bag should always be higher than the wall inlet of the sewage pipe or higher than the water level in the trap. If this is not the case, the wastewater will remain in the water bag until it reaches the isolation valve. In this sensitive area then suspended solids or residues settle and regularly lead to blockages.

Video Board: How To Wash Your Louis Vuitton In The Washing Machine | Clean With Me