Stick kitchen fronts - you should know that


If you want to freshen up your old, a bit worn kitchen, you are well advised to go for wrapping. What options there are to beautify a kitchen front with slides, and what you should know and pay attention, you will learn in this post.

Advantages of foliation

Foils are the simplest and most cost-effective means to transform furniture fundamentally. They are far cheaper than the complete replacement of kitchen fronts and offer more design options than the painting of kitchen fronts.

There are also other advantages:

  • Films are to be applied without dust and great effort
  • Transparencies can later be peeled off without a trace
  • With the help of foils you can easily cover minor damages and quirks and make them invisible (this is not always possible when painting)
  • high-quality films can be used for many years
  • High-quality films are not only waterproof but also heat-resistant
  • Sheets can also be applied without difficulty
  • With the help of foils, just about any desired design of the kitchen fronts can be achieved, including natural stone and concrete looks
  • Foils can be repaired very easily by re-polishing (remove the remaining film!)

Disadvantages of slides

The adhesive power of a film can usually not be determined in advance. How well a film holds is in many cases dependent on the manufacturer of the film - it is fixed measure or an indication of the adhesive force of a film is nowhere. Here you go a certain risk, with high-quality films, the adhesive power is usually very high and reliable.

The problem with the filming (as well as with painting) is that only the outside of the front is redesigned. The back of doors and drawers is usually not covered (usually not painted). When opening doors and cabinets, you can still see the original design on the inside, even after the foil has been varnished. Only in the closed state, the front shows in its redesigned form.

Prices for adhesive films

By far the most furniture and kitchen foils you get for a price of around 30 EUR per meter, the width is almost in all cases just over one meter. Since the height of the kitchen front is usually around 90 cm, you can work here with very little waste.

Calculated over the thumb so you have a cost of around 25 EUR - 30 EUR per meter of kitchen front. This is a bit more expensive than the painting (from about 10 - 15 EUR per m² front surface), but much easier and with less effort to accomplish.

film quality

Make sure that you always use a foil of the highest possible thickness. Thicker films offer better protection and are usually also higher quality. Ideally, the film should have a slight extensibility. It is best placed clean around corners and edges. For this you usually need a helper and a hair dryer.

The look of the design is also crucial. As a rule, the designs are photorealistic representations, especially with faux-films. This means that you can hardly distinguish them optically from the original material. Some films even have a slight structuring that approximates the material shown. As a rule, however, these are already a bit more expensive, especially high-quality adhesive films.

Another quality feature is the scratch resistance of a film. Ideally, there should be an additional, transparent protective layer over the foil decor that prevents scratching the decor. This avoids that the film is damaged over time - such damage is usually very noticeable, because they disturb the visual appearance of strong.

Also always make sure that a manufacturer marks his films as "washable" - especially when filming the kitchen is an extremely important criterion, so that the kitchen front can also be cleaned well.

Possible designs

Real wood

When filming, you can choose from numerous designs. Particularly popular for kitchens are above all real wood decors (some with realistic Strukuten to the optical effect still increase).

You can effectively transform your kitchen front in almost any type of wood in many different shades. The selection usually includes high-quality exotic woods, which you would never use in the original kitchen design (for example, expensive walnut wood). This will allow you to upgrade your kitchen.

concrete look

Concrete optics is particularly popular with modern facilities. Surfaces with concrete look are difficult to design, and in many cases the high weight of a very thin layer of concrete is a real problem.

With foils, a concrete look can be realized very easily and without great effort and technical problems. Different colors and textures are usually available in the designs.

Tips & Tricks

The filming itself is very simple: cut the film to the right size, then pull it piece by piece from the backing paper and smooth it with the squeegee. For corners, edges and profiles, heat the film lightly with a standard hair dryer and then put it under strong tension around the edge, pressing it firmly against the structure with the edge of the squeegee. It is best to always use a helper.


Video Board: 10 DIY Kitchen Cabinets Refacing Ideas