Fasten the wardrobe permanently and stably


The weight on a wardrobe should not be underestimated. In addition to the pure traction through the weight of the garments usually arise when suspended additional centrifugal forces by swinging. Also note the enormous weight that wet garments develop. High double-digit kilogram values ​​are possible.

stress factors

Who builds a wardrobe himself, usually chooses between a wall-mounted or a free-standing variant. Free-standing structures such as a mobile coat stand require either a large and heavy stand or must be supported by auxiliary fasteners.

The span of coat hooks has an additional major impact on the forces acting on a wardrobe. The farther the garments are from the center of gravity of a standing construction, the higher the weight loads the attachment must carry.

wall anchors

A thick winter jacket made from absorbent material can easily weigh up to ten kilograms after a rainstorm. Hung with swing on the coat hooks, individual swinging motions increase short-term punctual force effects up to fifty kilograms. When mounting, the number and durability of the attachment points must maintain this force.

Nails can not withstand these forces. A coat rack mounted flat on the wall should always be fastened with screws set in dowel holes. As a rule of thumb can be assumed from about a screw point for two suspension options. The screws should have a minimum diameter of eight millimeters and have the appropriate anchor length.

The same screw dimensions also apply to holding structures for vertical wardrobes, for example, from a log. Circumferential clamps or rings provide the safest support protection. As the yardstick of the overall construction, the weakest connection point must always be taken into account.

Holding wires, steel cables and special glue

If a more elegant and visually less conspicuous mounting structure is to be created, steel cables serve well. Like tented ropes, they can stably block movements in any direction through physically cleverly distributing the course of the course.

Manufacturers of adhesive tape and glue products offer very strong adhesive double-sided fastening aids. The holding capacity is sufficient for cloakrooms in many cases. It should be remembered, however, that this remarkable durability also works on any subsequent disassembly on the wall.

Tips & Tricks

If you want to get along without drilling, you can consider whether a telescope construction is feasible. The resilient spring bars typical for shower curtains "pinch" between two counterpoints without damaging the wall.


Video Board: How to Make Wardrobe. Work with Melamine. DIY Wardrobe